![]() ![]() This guide uses a template for ventoy releases, you will have to replace 1.0.xx with the current ventoy release name. You need Windows or Linux to create a Ventoy drive initially, but you can add/remove ISO files to it on any system that supports exFAT. Ventoy is an useful tool that can create USB drives which can have more than one ISO at once, rather than traditional ISO writers, which can only use one ISO at a time. This site uses Just the Docs, a documentation theme for Jekyll. Making a GPT Partition Table in Diskpart. ![]() Securing Data Before Device Disposal or Transfer.Reading Machine Temperatures & Voltages.After booting the live media, start the installer and follow the guided installation procedure.We recommend to boot the drive in UEFI mode if listed. Each command uses the same device and media but boots the PC in a different firmware mode. For example, you might see UEFI USB Drive and BIOS USB drive. You might see separate commands for the same device. From the setup utility, boot to the usb drive:.Create a bootable USB using DD/Etcher/Ventoy/Rufus.UEFI is much preferred over BIOS whenever possible. If your firmware supports UEFI then configure your device to use UEFI only in its setup utility.Otherwise, the Linux kernel may not be able to detect your drive. Make sure that your device's SATA controller is set to AHCI mode in your device's setup utility.Check the manual of your device/motherboard for further info. It may not be possible to disable the latter explicitly - try clearing the secure boot keys instead. Common keys used: Esc, Delete, F1, F2, F9, F10, F11, or F12. Boot the PC and press the manufacturer specific key to open your device's setup utility. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |